Fixture Profile Request - Cineo Standard 410 new DMX control

Cineo Standard 410 profiles 2018-08-02 16-18-51.esf

Sasha-

I built the profiles that are attached in this show file, and they all work. However the address count that's automagically appended to the fixture type in patch doesn't show correctly on the profiles I built.

Is there a fix that I can do, or is that something that only ETC can fix?

Thanks!

The address count doesn't show up properly when you assign a fixture type to a channel. See attached screen shot.

Other fixtures show foot print.
For example, the S4 LED S2 Lustr HSIC StrFan shows [7] when picking a fixture type, though it only has 6 parameters. In the fixture editor it shows 6 [7].
Maybe the fixtures I created show [4] because I started by copying the existing Cineo Standard 410 profile that has 4 parameters and uses 4 addresses?

Other fixtures show foot print.
For example, the S4 LED S2 Lustr HSIC StrFan shows [7] when picking a fixture type, though it only has 6 parameters. In the fixture editor it shows 6 [7].
Maybe the fixtures I created show [4] because I started by copying the existing Cineo Standard 410 profile that has 4 parameters and uses 4 addresses?