Beginner patching undo

I managed to patch a few addresses to a single channel that I did not want to. And then in trying to undo it, P1. P2. P3. Showed up. Very simply how do I clear that info from the channel and start on that channel from scratch? It’s ridiculous how an accidental click or two can lead to such frustration.

0 Jeff Toussieng over 6 years ago

When in Channel patch mode:

Channel # @ 0 Enter Enter or Channel # @ Enter Enter will remove the address however leave the fixture type, etc.

Channel # {Unpatch} Enter Enter restores to default properties - it removes address, type, label, etc. Including parts

Delete Channel # Enter Enter deletes the whole channel from the show. BE VERY CAREFUL WITH THIS. IF YOU ALREADY HAVE CHANNELS RECORDED ANYWHERE IN YOUR SHOW AND YOU DELETE THE CHANNEL FROM PATCH IT WILL COMPLETELY REMOVE IT FROM EVERY LOCATION IN YOUR SHOW.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ueliriegg over 6 years ago

The P is for part. So to get rid of the Ps type Delete 1 Part 2 + 3 Enter (where 1 is the channel number) and Enter again to confirm
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel