Hello, I have two questions about pre-visualization using EOS. First, how do I get the EOS offline to talk to Wysiwyg R22 on the same computer? I've tried everything and it still does not see it. I bind an EDMX output to EOS 8K or 4K board in device manager. I even just tried using ETCnet2 to see if that would work. On the EOS offline, I enabled the all the ethernet protocols and outputted them offline. I even added a loopback adapter. Still nothing. Am I missing something here?
Second question: because I could not get Wysiwyg to work, I am using another pre-viz program called Light Converse which seems to work great and I am only outputting Art-Net from EOS. The only problem I have is that it does not create a fluid movement with the lights since the network packets being sent are intermittent. I tried everything imaginable to increase the network speed between programs but same problems. I know that the pre-viz software is fine because I run GrandMA on Light Converse and it runs as fluid as water. Also, in addition to the jerky signal, I also get network spikes every couple of seconds that brings all my lights to full then goes out. This is all getting quite annoying which is why I am trying to get my Wysiwyg to work. Any help anybody can give me on these problems would be greatly appreciated.
Thanks
