Reverse engineer fixture library

The library information and the update can be found here: http://www.etcconnect.com/Products/Consoles/Eos-Family/Eos-Ti/Software.aspx

The HTML is simply a list of all fixtures in the library including what was added in this patch installer- so you can see what profiles exist up to this point in time.

Thank you for the reply Sasha.  However, what I've found doesn't provide the solution to my issue.  I've five different fixtures (a total of 26 instruments) that I'd like to find out if they're in the library or if I should submit them.  I was hoping to be able to see what was already in the library and compare those configurations to the fixtures I have.

Or, is there a "fixture editor" so that I can just create these configurations myself?

The HTML should give you the list as you desire-- it shows all the fixtures that are in the library.
You can create fixtures on the console itself- in Patch> {Fixtures}  http://www.etcconnect.com/webdocs/Controls/EosFamilyOnlineHelp/en-us/Default.htm#Patch/Fixture_Editor.htm%3FTocPath%3DPatch%7CFixture%2520Editor%7C_____0

Eos has a fully featured fixture editor built in that gives you the ability to view and edit library fixtures, or create your own from scratch. Go to Patch > Fixtures.

Maybe onyxfixturefinder.com will help you. It can show you aliases which you then can look up. Usually one of them already exists in the library

found four out of five fixtures in the onyxfixturefinder.com library.  found a -close- substitute for the fifth.

now the question is, are the fixture names listed in onyx....com the same as listed in the EOS fixture library?

and Thank You *VERY* much for the pointer to onyx!!
jack

Thank you for the pointer on getting to the fixture editor.  I created a fixture and it works.  *But* I managed to get some extra entries in the profile.  How do I get rid of the extra entries or do I even need to worry about them?