iRFR Remote Connect issues after V3.0 Update

what version of the iRFR-BTS app are you running?
Is the IP of your apple device still in the same range as the ETCnomad and Console?

wish is RFR Version: 4.0.0.39

Full version 

Current and updated IOS also

This is not a know bug and testing here shows that v4.0.0.39 of the app connects just fine to consoles running v3.0.
Can you please share more information about your network setup?

Not much to tell really. In my home studio I usually use my iPad as a remote screen with my laptop running nomad

Well knowing that it isn't a bug, then I am not sure what to do. Ill keep trying and maybe try uninstalling the remote from my devices and trying again. It used to work no problem and connect within seconds until i updated it. All good, thanks for your help. 

if augment3d is running on the nomad (because you have Tab 38 open, or had it open in this session), the discovery process of the iRFR can be slowed down. i had a case where it took almost half a minute to discover.

Hey all... Marcus with Tech Support sorted the issue... was a silly mistake on my part. I didn't notice the unchecked box here.... 

• Within the EOS shell, under Settings>Network
  • The selected network interface is the correct interface exposed to the WiFi
  • “WiFi Remote” is ticked for the appropriate network interface

PROBLEM RESOLVED :)

Hey all... Marcus with Tech Support sorted the issue... was a silly mistake on my part. I didn't notice the unchecked box here.... 

• Within the EOS shell, under Settings>Network
  • The selected network interface is the correct interface exposed to the WiFi
  • “WiFi Remote” is ticked for the appropriate network interface

PROBLEM RESOLVED :)