[Bug?] Tether Mode isn't working

Brand-new Xe20, two different PC's running Nomad on the same subnet, all are Eos 3.0.0.389 & Fixture library 3.0.0.134.

With the Xe20 as primary, I can connect the nomads as clients, mirrors, or backups without issue. Everything works fine. I can view Augment3d on the secondary consoles and see stuff happening. I can run other visualizers on the secondary machines and see stuff happening.

But when I attempt to run the nomads in Tether mode, no dice. The screen displays "Waiting for console to connect..." and stays there. No settings were changed.

Any tips?

Top Replies

Parents

sktusing over 3 years ago

Have you linked one of your consoles to the tether?

Check here: https://support.etcconnect.com/ETC/Consoles/Augment3d/Stuck_on_'Waiting_for_Console_to_Connect'_When_Launching_Augment3d

and here:

www.etcconnect.com/.../Default.htm
Cancel
Vote Up +2 Vote Down

Sign in to reply

Cancel
mdrohn over 3 years ago in reply to sktusing

Aha! I wasn't aware of the step on the primary to direct data to the tether. Thanks, that did it!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
ueliriegg over 3 years ago in reply to mdrohn

just as a small side-fact, maybe it helps somebody in the future: Augment3d doesn't care about sACN data. so the fact that sACN arrives at the tether computer only proves that there is a network connection, but not much else. that's also why Augment3d works with channels that haven't been patched to an address.
Cancel
Vote Up +2 Vote Down

Sign in to reply

Cancel

Reply

ueliriegg over 3 years ago in reply to mdrohn

just as a small side-fact, maybe it helps somebody in the future: Augment3d doesn't care about sACN data. so the fact that sACN arrives at the tether computer only proves that there is a network connection, but not much else. that's also why Augment3d works with channels that haven't been patched to an address.
Cancel
Vote Up +2 Vote Down

Sign in to reply

Cancel

Children

No Data