Macro triggering channels fading the channels

What is the syntax in the macro?  

Just whatever show control its turning on/off and duty channels either at full or 0. Thats it, nothing else

maybe your User 0 has manual timing set.

I tried all 5 users and they're all set to 0 manual timing. I tried going to user 0 and it wouldn't let me. I should also add that I'm on 3.0.1

I tried all 5 users and they're all set to 0 manual timing. I tried going to user 0 and it wouldn't let me. I should also add that I'm on 3.0.1

you're running the macro in background mode, so it executes in user 0. my guess is if you change it to foreground mode it will snap the channels.

Yea putting it onto foreground fixed it. Thanks Ueli! When turning a channel on in a macro that's in background mode, it's always going to made up the channel?

no, only if User 0 thinks it has a manual timing setting in setup

Is there a way to check that and change it?

learn a macro that heads into setup and sets all manual times to 0. and then run that macro on user 0

Perfect. That fixed it. I didn't even know about User 0. Ueli to the rescue again! Cheers!