3.0.2
Flexi Active has two different behaviors for marking channels:
AutoMark Enable
Chan 1 is Generic LED RGB 8b
Cue 1: Chan 1 Full in red
Cue 2: Chan 1 out
Cue 3: Chan 1 Full in blue
From Cue 1 press Go for Cue 2. Channel 1 fades out, then shows green MK and stays on screen. This is expected behavior
From Cue 1 press Shift+Go. Channel 1 shows magenta MK for a fraction of a second and the disappears. This is not expected.
From Cue 1 do a GotoCue 2 Enter. Channel 1 shows magenta MK for a fraction of a second and the disappears. This is not expected.
No matter how i get to a certain cue, i would expect that the color of the information is the same (as soon as the transition is done).
And no matter how i get to a certain cue, i would expect that Flexi Active show the same channels in the same situation.
Thx, ueli