Fixture Editor re-addressing Patched Fixture Bug

Hello

Are there any gaps in your profile (for example:  an offset is not assigned to any parameter)?  If so this may be related to another bug we have.  Please let us know.

No offsets are showing up.  1-240 are the Cells and 241-243 are the Parent parameters which are all in the Beam Category.  

RELATED?  Separate bug but probably what you are asking about Sasha.  If I'm duplicating Cells while I'm editing, the OFFSET of the 2 cell seems to reference the amount of addresses used in the Master Cell.  So, if there are 3 addresses in the Master, the SECOND Cell starts counting its first address at 4.  The first Cell is fine.  For example, Cell 1 uses address 1-7, Cell 2 starts numbering at 4--now 2 cells using the same address--and the rest of the cells are numbered following the 2 cell's erroneous numbering.)

RELATED?  Separate bug but probably what you are asking about Sasha.  If I'm duplicating Cells while I'm editing, the OFFSET of the 2 cell seems to reference the amount of addresses used in the Master Cell.  So, if there are 3 addresses in the Master, the SECOND Cell starts counting its first address at 4.  The first Cell is fine.  For example, Cell 1 uses address 1-7, Cell 2 starts numbering at 4--now 2 cells using the same address--and the rest of the cells are numbered following the 2 cell's erroneous numbering.)

yes, I think this is the already reported issue (or related to it)
I'm trying to replicate your issue so I can get it written up.  I'm out of the office tomorrow so if I don't respond I'm not ignoring you and I will get this reported.

I still cannot replicate this issue.  Would you be willing/able to share your show file?

Yes.  I can send it to your email.  I can't share it here publicly.  Can you tell me where to send it?