Patching multi channel light to separated addresses

Is there a way to patch a multi-channel light to DMX addresses which are separated? For example, I have an LED light, in a mode which requires 10 addresses. My universe is used up with other patches, but I have over 10 addresses that are free. Unfortunately, these available addresses are not next to each other, but peppered throughout the universe. (i.e. available addresses: 12, 18, 30, 41-46, 271, 423, 424,. Utilizing these to patch one 10 address required light.)

Is it possible to utilize these free addresses which are separated by other patched lights and make my LED light function?

Parents

0 mathilda over 2 years ago

the question is, can the fixture get it as well?

Normaly you tell the Fixture a startaddress and from here on the Fixture would count the required DMX-Addresses up.

Before doing some fine magic in the desk, please check your Fixture first ; )
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 mathilda over 2 years ago

the question is, can the fixture get it as well?

Normaly you tell the Fixture a startaddress and from here on the Fixture would count the required DMX-Addresses up.

Before doing some fine magic in the desk, please check your Fixture first ; )
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 ueliriegg over 2 years ago in reply to mathilda

mathilda is absolutly correct. i was ignoring the reality of lighting fixtures. just because you can do this on the console side doesn't mean your fixture will be able to understand what's going on (and the fixture 99.9% will not be creative enough).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel