Martin Thrill Vertical Fogger sets fog at 100% in previous cue

Using ETC profile for Martin Thrill Vertical Fogger.

When I program it in the cue it automatically sets the fog to 100% in the previous cue. Even when I go back and lower level to 0% it automatically resets it 100%

I'm probably missing something simple to fix this..

ueliriegg over 2 years ago

this is a question of automark. because the intensity is at 0, automark tries to already put the non-intensity paramters at their next level. solution is to disable automark for that cue (or cue part), or to have an intensity, e.g. 01%
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
ParkerTheatre over 2 years ago in reply to ueliriegg

Yes, The Fog is under FORM parameter so it was seeing the AUTOMARK. I finally figured out how to do it. Thanks!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Theatermachine over 2 years ago in reply to ueliriegg

This means the fixture is not written correct by ETC. Fog output should always be an intensity parameter to make sure it never ends up in an automark. Otherwise your other movers must be marked manually for that cue.

You can always rewrite the fixture profile.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel