Busking Macro - Stop then Restart Effects

Query Effect Enter should select all channels running an effect, i think?

Yes. But what I’m looking to find is a macro that restores all effects that were running Before my “all stop” macro. 

What did your macros look like when they still worked? And which software version was that?

Sorry for the huge delay in response, I've been away on leave.

Honesty, it was super simple. 

The first (for stopping everything) is: "Select Active.  Effects.  Enter"

The other (to restore the effects, which no longer works) is:"Undo. Enter."

This worked on everything before 2.9

When I updated to 3.1, "Undo" no longer restores all of the previously running effects.

Is there a better way to do what I'm trying to do?

Sorry for the huge delay in response, I've been away on leave.

Honesty, it was super simple. 

The first (for stopping everything) is: "Select Active.  Effects.  Enter"

The other (to restore the effects, which no longer works) is:"Undo. Enter."

This worked on everything before 2.9

When I updated to 3.1, "Undo" no longer restores all of the previously running effects.

Is there a better way to do what I'm trying to do?

You could try not to stop the effects, but to set the effect size or rate to 0 and then back to 100 when you need to restart them. 

What about:

[Select Manual] [Record] [Preset] (##) [Enter] + [Effects] [Enter]

Then [Select Last] [Preset] (##) [Enter] to restore? Make it a Macro so that Preset is always your return state.

Winner!  I've been racking my brain for so long.  Thank you so very much!

Not a bad idea!  But it wouldn't 'snap' everything to their base state, which would be ideal.  That being said, I will absolutely be utilizing your suggestion as well!