Sneak all the time / Sneak on GO

1: look into the Manual Time fader

2: values sneak (i.e. fade to the value in the cue) if there is a move instruction in the cue. if there is not, the value will stay on it's manual level. unless the incoming cue has an Assert flag or is considered an Out Of Sequence move (GoToCue, Back, Loop, ...).
the reason why captured values don't move when you press go is that this is exactly what Capture is made for. the usercaptures manual values if they want to prevent the values from being overriden by Go.

Great about the Manual Time fader ! Thanks

Unfortunately the second topic doesn't work for me...even if I have values recorded in the cue, the manual values stay manual, even when there is an Assert. It works for Out-Of-Sequence cues though

Is it something that I need to change in the setup ?

if manual values don't move away although they have a move instruction in the incoming cue, then your channels are either selected or captured. correct?

there's nothing in setup in respect to this

if manual values don't move away although they have a move instruction in the incoming cue, then your channels are either selected or captured. correct?

there's nothing in setup in respect to this

That was it ! I didn't think the selection had any effect

Thank you so much !

a selected channel with manual values is considered captured.