Rig wide lamping off.

Hi Vicki-

This shouldn't be a problem. If you select all of your movers, then go to [About], then {Lamp Controls}, you should see Lamp Off as an option.

-luke-

Cheers Luke,

I'm just learning the EOS at the moment before our first shows start coming in and I only have one mac 250 to use as a test unit!

Quite difficult to see if multiple branded units will lamp off when you only have one to work with...

: )

vicki,

I have two macros written that lamp on and lamp off my movers. Every show i just go in and change the fixture numbers.

It was easier doing that and leaving the macros up on the top right direct selects, and I still have the ability to get to the lamp controls to just command individual fixtures.

what i typically do with my shows is build a ML Group, and have a macro built in to lamp that group on and another macro to lamp it off.

same sort of idea, just easier in my opinion to update the fixture numbers [i.e. [ch #]  [thru]  [ch 3] [update]  [group]  [group #] ] then everything is updated :-)