Fader Wing Sub LEDs after 1.8 upgrade

Hi Bryan-

This is normal behaviour - in fact I would have expected them to do this on whatever previous version you had as well.

Is it possible that the fader wing was showing different pages before? I would think that after a software upgrade, both the console and wings would default to page 1 again. You can change this by holding the [Fader Page] button and selecting a page on the bump buttons.

-luke-

Maybe I should have clarified. 

I know the LED should flash when the handle level doesn't match the actual level of the sub (if I bring the sub up on the console and have a matching sub on the fader wing) however what is happening is as soon as I bring a handle up above 0% the LED on that same handle begins to flash until I return the handle to 0%.

This only happens on my fader wings, the same operation with the on board faders does not produce the same results.

Maybe I should have clarified. 

I know the LED should flash when the handle level doesn't match the actual level of the sub (if I bring the sub up on the console and have a matching sub on the fader wing) however what is happening is as soon as I bring a handle up above 0% the LED on that same handle begins to flash until I return the handle to 0%.

This only happens on my fader wings, the same operation with the on board faders does not produce the same results.

Hmmm... that doesn't sound right.  Can you email me your showfile?  Will see if its reproduceable on another system and we will go from there.  Can you remind me what the issue is when you send the email?

Thanks much!

a

I'm curious about this.  We're about to upgade to 1.8 and this would certainly be a change from 1.7.

We are not seeing this in our lab.  This has been forwarded to Tech Services to take a look at.

Ann

I did a deep clear and everything seems to be working as it did before the update. 

Anne, should I still send my show file?

Nope, not unless you have another issue.

Thanks much!

a