Fixtures stuck in certain colour palettes.

Hi, we found another strange anomoly today.

First we had a VL3500 that was put into R13 via direct command line; [CHANNEL][1] @ [COLOUR] 6/13 [ENTER]

LD fancied something a bit darker so tried R15. Same command line but colour didn't change. Then tried R90 (just to make sure it wasn't changing) and same thing. Couldn't take the colour out or change it all until I selected COLOUR HOME on the encoders. After that it worked fine.

Thought it was a one off until later when tried to move a Rainbow scroller from one colour to another (this time via colour palettes) and again it wouldn't change colour until after a COLOUR HOME command. Is there some sort of colour lock or some other obvious answer I'm missing?

Cheers, Liam.

Parents

Anne Valentino over 15 years ago

Hi Liam. No, there isn't a color lock. Can you recall if the color didn't change, but the display did?

Can you drop me your show file? I'll take a look.

thanks much,

a
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
liamjf over 15 years ago in reply to Anne Valentino

Hi Anne, yes the display changed and said it was in the new colour but the fixture stayed in the previous colour. Wouldn't change colour at all until we "Homed" it. I can send you the show file once I get back to work tomorrow. Thanks for looking into this (BTW it hasn't done it this week at all!)

Liam.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

liamjf over 15 years ago in reply to Anne Valentino

Hi Anne, yes the display changed and said it was in the new colour but the fixture stayed in the previous colour. Wouldn't change colour at all until we "Homed" it. I can send you the show file once I get back to work tomorrow. Thanks for looking into this (BTW it hasn't done it this week at all!)

Liam.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data