profile for Chinly 12 channel ... H DMX 512 Decoder

Question

I need help finding a profile for an LED strip, using a Chinly 12 channel ... H DMX 512 Decoder. That's all I know. I have tried the Generic LED RGB profiles with no luck. Any ideas? Thanks

mathilda · Accepted Answer

Hi Stephen, 
 the Decoder itself is not what you are searching for in the first place. More important is; what are you going to operate with it. 
 1. Are you using a single LED-Strip 2. Are you using Multiple LED Strips, but like to control them as they are one 3. Are you using Multiple LED Strips and like to have them as separate Fixtures to control 
 For 1.: You can go with your "Generic LED RGB" Fixture For 2.: You can use you "Generic LED RGB" Fixture and patch as much Parts, of the same Fixture-Type, as you like For 3.: You can use your " Generic LED RGB" Fixture and make: A: every LED Strip a single Channel B: create a Multicell fixture based on a "Generic LED RGB" Fixture for each Cell 
 That is, what pops into my Mind.

Geoff Crisp · Answer

Hi Stephen, 
 These decoders are similar to the ones I use. Essentially it is a decoder for 4 strips of RGB LED. so what you do is patch as a generic RGB fixture at the starting address. If you only need one strip then you only need 1 channel. If you want to use 4 strips then assign them to 4 separate generic RGB fixtures and the addresses will be consecutive. I have also used multiple single colour strips in the one fixture strip such as Ch 1,2&3 all red strips assigned as dimmers and then ran effects over them. 
 Hope this helps. 
 Geoff

profile for Chinly 12 channel ... H DMX 512 Decoder

Top Replies