Artnet Subnet - how to enter the number in Nomad?

Question

Hi, just ran into a problem in a venue, where the house system requires Artnet input on (Artnet) Subnet 1. In my understanding this must be set under "Patch>Protocols>ArtNet>Start Universe", where it says (0:0:0). Second number being the subnet, right? But how to enter it? Any number is turned into a Starting universe (third number) and I cannot write a ":". 
 
 thanks, Marcel

mathilda · Accepted Answer

Here is a Handy Table: https://support.etcconnect.com/HES/Consoles/Hog_4/Networking/ArtNet_Conversion_Table 
 The Subnet of 1 is entered(automaticely), if you use a Universe higher than 15 and lower than 33. 
 The composition of the ArtNet Universe is a bit different than sACN ;)

Artnet Subnet - how to enter the number in Nomad?

Top Replies