Using Manual faders on Ion Xe20 board

Question

I have replaced my old Element I Light Board with a nice new Ion Xe20 board. But I can not figure out how to use the manual faders on the new board. The User Manual is of no help -- it only describes the procedure for using manual faders on the ELEMENT Board, and I already know how to do that. How do I select channels so that I can manually adjust intensity with the faders? What is the "Fader Page" button for? Where can I get a user manual to help me?

eos moderator · Answer

Thank you for reaching out. 
 You can set the Ion Xe20's fader to channel mode by holding the [FaderPage] button pressed and then hitting the bump button of fader 20. 
 While FaderPage is pressed the fader display will show this for the last faders 
 This is what you'll see afterwards 
 Other than that the [FaderPage] button allows you to page up to the next fader page, with Shift you can page down. 
 Does that help?

Using Manual faders on Ion Xe20 board

Top Replies