How do you patch in fixtures if using DMX outlets from the back of the console?

In the setup there is an output section. You define what is going to the ports of console there. If you usually use a node you might find that the 2 ports on the console are U1 and U2. (assuming you only have 2 DMX ports.

On ver 3.1.5 you will find them under setup, device, local output.

Regards

Geoff

Thanks Geoff. I found where you were referring to. See attached images.  

But just incase. 

1. In Brower select setup/Device Setting

2. Under Device select Local Output.

Just for completeness' sake, because I can't see the images you attached:

Setup > Device > Local Output

The number in the Port column is the numbering you can see at the back of the console. Address is the first address being output from that port.

In my example the first port is set to universe 3, ports 2-4 are all set to universe 4.

Just for completeness' sake, because I can't see the images you attached:

Setup > Device > Local Output

The number in the Port column is the numbering you can see at the back of the console. Address is the first address being output from that port.

In my example the first port is set to universe 3, ports 2-4 are all set to universe 4.