Anyone have advice on how to use the GLP X5 Multi-Cell profile on EOS? I want to run the fixture in Mode 2 (35 Channel Mode) and have access to the built in effects engine of the fixture. Just want advice on how to use the profile since I can't totally

Question

Essentially building a show with 13 GLP X5's in the rig. I know the X5's have a built in "gobo wheel" of different static and moving effects & patterns and I would love to figure out how to get control of these different effects. I definitely want the fixture to be in a multi-cell mode but it's possible I might also need to change settings on the fixture itself. The X5 is set to 35 channel mode, and is patched on the console as Mode 2 (35 Channels) Multi-Cell. Again, just want advice on how to use the profile on the console. Thanks!

eos moderator · Answer

You're looking for the Pixel Mask parameters that you can find in cell 5 (if you're using the 7 cell version of the profile) or cell 6 (in the 8 cell version). 
 I am however not convinced that you need a multicell profile to control this fixture. An argument could be made for a two cell profile, but the 7 and 8 cell versions seem a bit excessive...