Hey all,
Interesting challenge.
I have a Highend Lonestar that is mis behaving, its not the fixture, that much has been deduced.
The show uses quite a few presets and palletes as normal. The fixture responds perfectly when bouncing around most of these until it goes to a specific preset (23), at which point the fixture slows down to a crawling pace. if I try to send it to other positions, even using the pan/tilt controls, it stays slow until I release it, then it moves full speed again until that preset gets recalled. I have tried to update the preset and we have a substantial amount of cues in the board already. Augment3d shows it moving at a regular speed.
Console is Apex 5, any help would be appreciated
