Bug? Group cue part.

Question

I don't get this and it feels like a bug. 
 When I'm typing [Group][cue][part][2] I get the selection with the channels from the group. However if i want to continue typing and for example remove channel 1 from that selection, Im all of a sudden getting the whole cue grouped instead. 
 I couldn't find a way to group a part and then continue working with that selection. 
 The workaround to make it work for this specific case was [ Group][cue][part][2] {Make Manua} [Select Manual]. 
 I'm on a Apex 20, tried on my computer and sam thing happened. 3.2.6 build 29.

jolson · Answer

So if I do [Group][Cue][Part][2][-][1] [a] [/50] it properly drops intensity by 50% on only those channels in part 2 excluding channel 1. Just make sure that you do NOT press enter after part 2.... This works properly yin 3.2.7 that was just released, but I that should work in 3.2.6 as well.

eos moderator · Answer

Thank you for your report. I can see what your describing and will do some more research. 
 What I can say so far is that since the introduction of this syntax in version 3.0 it has never done what you expect it to do. The workaround is to use Query.

eos moderator · Answer

This was written up to be fixed in a future software version. 
 [EOS-55619] [Group Cue x Part y] syntax not appendable after Enter