Nomad on Mac Mini intermittently stops sending sACN

I'm running Nomad 3.2.7.18 on a 2012 Mac Mini with 8GB of memory.  I have a Gadget with 2 universes and I'm sending two additional universes to Pathport Uno interfaces.

Most of the time it works fine and I get the correct outputs on all 4 universes.  If it matters I have a 1024 address dongle and I'm using 1006 addresses across all 4 universes.

Intermittently the Pathports will individually stop receiving sACN - the display changes from "LiveOut" to "IdleOut".  Usually it's only one at a time and the other one is fine, but sometimes both will go out together,

I put a laptop on the same network and Wireshark shows that the affected universe is not being sent over the wire, which explains why the Pathport can't see it.

Are there any special network settings required to ensure that a Mac Mini doesn't mishandle sACN network traffic?

Thanks

Parents Reply Children
  • Great that you got it to work!

    This sounds a bit like your switch is struggling with multicast or with the load. 4 universes shouldn't be a problem for anything less than 10-15 years old, but the culprit could be the configuration of the switch.

  • This does sound like a switch issue. Out of curiosity, is there a TP-Link switch on the network? I’ve encountered an identical situation numerous times where sACN output intermittently drops. Every time that I’ve encountered it, there was a TP-Link switch in line between the source and receiver. And every time the problem was solved by swapping out the switch for another brand. 

    I suspect an issue with the IGMP Snooping capabilities or capacity of the switches. Using Unicast also explains why this would fix the issue as the switch isn’t having to route Multicast packets to your receiver.

  • Yep - in this case a TL-SG1005P, the only switch connecting the Mac Mini to the Pathports.  I figured since it's unmanaged it would leave the IGMP alone - I guess that was a bad assumption.  I'll try it with a Netgear switch and see if the same thing happens, although I think I'll stay with unicast anyway since it's much more efficient and not that much effort to configure.  Thanks for the pointer!

Related