Ion 1.9 and HES I-beam 700hx's

ok, so I'm started this year's show by merging parts of last year's show. During each of these shows, i'm using the same HES i-beams, but I'm now about three software updates ahead. when I do Chn # About, no lamp controls are available this year, but they were before. How am I supposed to lamp off these fixtures?

Any help is appreciated.

0 Anne Valentino over 15 years ago

Looking into this. Back shortly.

a
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 derekleffew over 15 years ago

I'm likely wrong, but I seem to recall the only way to Lamp Off an Intellabeam, even in 13-ch mode, is to remove DMX and wait for the fixture to time out and "sleep."
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 BoredAlwys over 15 years ago in reply to derekleffew

After looking again in the manual, I believe you are probably right, and I'm mistaken about last year, because the manual says nothing about a control channel in DMX mode.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Anne Valentino over 15 years ago in reply to BoredAlwys

We did check back to 1.4.5 released code. The Global Reset that appears on one of the i-beams is the only lamp control that has ever been there. So, there don't appear to be control channel functions.

a
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel