How to stop console booting in backup mode

Question

Hi All 
 the gremlins or little fingers have been at the console whilst I've been away. 
 It now boots up in Back up mode (it's not on any network), i can change it manually but like it to boot up as the main. 
 Also while I'm on here, is there a way of getting to the shell display without powering down etc? 
 Element Classic Running 3.2.6 Build 29 
 Thx 
 Phil.

eos moderator · Accepted Answer

Your console should always boot up to the last mode it was in. So if it's shut down after running in Primary it should start up as Primary again. 
 To get from the software to the shell: [Displays] > Exit 
 In the shell in Setup > General there's also a setting if you want to boot up process to end or if you want to automatically continue into the software.

How to stop console booting in backup mode

Top Replies