Bug? Snapshot not recalling Temporary Fader Mapping List

Hi there,

I'm not sure if this is intended or not, but I have a fader that contains 2 presets to do single shot FXs. There are 2 presets, each has the same effect but different target numbers so I can bump them back to back even if the effect is not finished. I have different fader mapping for the 2 acts of the show and would like to switch the mapping with a snapshot. Everything is working properly except the Presets mapped to faders, upon recall, they only populate the fader with the first preset listed. Is this intentional behaviour, I would hope not, but it's possible.

Thanks,

Tyler

Running 3.2.10.36 on macOS

0 mathilda 2 days ago

Are you switching Fader pages with your Snapshot or have you deleted the Temp. Fader Map and made a new one?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 tylerandrew 2 days ago in reply to mathilda

New Fader map, ACT 1, uses fader 1/1 -> 68/1, in ACT 2, I would like to continue to use further subs but map them back down to the same range. (It's a live music show with a lot of sub bumps)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mathilda 6 hours ago

I think the biggest problem you are running into is, that the Temp Fader Map is nowhere realy stored.
If you overwrite it or delete it, it is gone forever.

And, as far as i read the manual correct, you can't make 2 Sets, because the limit is 100 Faderpages.

So you can make a big mess with copy from A to B to C to A....
What a trouble.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel