Multiple parameters on one DMX address

Question

I'm attempting to make a fixture profile for an older LEDJ LED07 starcloth driver, and it behaves in a way that seems to be impossible to configure in EOS - at least to me, as a relative novice when it comes to custom fixture definitions. 
 The fixture behaves like so: 
 
 Addresses 1-4 correspond to the 4 sets of LEDs, I assume I'll need to treat these as 4 cells 
 Address 5 selects the cell behaviour (for all 4 cells) from two options 
 With address 5 in DMX0-100, the cells treat their DMX value (0-255) as the rate at which to flash/twinkle/pulse (at full intensity) 
 With address 5 in DMX101-255, the cells treat their DMX value as an intensity control instead (statically on, no twinkle etc) 
 
 Is there any way to have the interface show the cells' "intensity" and "flash speed" (or other relevant labels) as separate controls alongside a master "mode switcher"? If not, eh, I'm sure I can work around it for this one show even if that means treating it as 5 separate dimmers

omegazeta · Answer

The best way to do this is to setup a multi-cell fixture with a master cell that controls the cell behavior channel and 4 cells with intensity. The slightly more complex stuff is remembering to set the master cell to have an offset of 5, setting up two ranges (Flash/Static) so that you can vary the flash rate/lock it in static. I took a crack at it and this is what I came up with: 
 LEDJ LED07 2025-03-15 14-26-09.esf3d 
 Hope this works for you, just merge in fixtures from this file.