I have a cue where a light is moving.
The cue is split into parts, and for the light the pan is in part 1, the tilt is in part 2. Pan and tilt are referencing a preset.
For housekeeping reasons I go:
Cue 1 Part 2 MOVE TO part 3
The part is renumbered correctly, but the tilt data for my light is now showing a hard value rather than a preset reference.
This is wrong.
If the pan and tilt are in the same part
Interestingly sometimes - but not always - if both pan and tilt are in the same part, then moving that part to a different part number causes the PAN to lose its reference to the preset.
This is 3.2.10b36 on a Ti.
Thanks!
Rob.