Hi ETC and everyone.
recently upgraded to 3.2.12.1
I've got 8 channels showing grey intensities of 25, but not the "N" for null.
I can't sneak them out.
they come up when the console boots up.
"About" shows a Value of 25, but the DMX output is 0
If I take the channels to full, the intensity rolls up; I can sneak the channel down to 0, but then the intensity jumps back to 25
they show the intensity of 25%, but the light doesn't actually come on. .. . .
I deep cleared the console and reloaded the show, but they came back. . . .
Thoughts?
the channels are typically controlled by subs (work lights and moving light non-dim channels)
the channels are patched to a Non-Dim at 50 profile (and i updated the profile when I upgraded the software)
Thanks.
Andrew
