Assert Block does not terminate previous cue fade

This feature works correctly when I tested it. My first guess is that it might have to do with when the BLOCK was set on the cue. When in doubt always start with a simple example, so here is a test I would suggest...

Cue 1 -- channel 1 @ 50

Cue 2 -- channel 1 @ FL with a cue time of 15 seconds

Cue 3 -- channel 1 @ 0 with a cue time of 0 second, then also BLOCK & ASSERT on this cue

Start in cue 1, then go cue 2, and then a second into it, go for cue 3 and it should immediately jump to 0, no fading since timing was at zero.

This feature works correctly when I tested it. My first guess is that it might have to do with when the BLOCK was set on the cue. When in doubt always start with a simple example, so here is a test I would suggest...

Cue 1 -- channel 1 @ 50

Cue 2 -- channel 1 @ FL with a cue time of 15 seconds

Cue 3 -- channel 1 @ 0 with a cue time of 0 second, then also BLOCK & ASSERT on this cue

Start in cue 1, then go cue 2, and then a second into it, go for cue 3 and it should immediately jump to 0, no fading since timing was at zero.