Hello,
I'm trying to get my NOMAD to connect to a wLED controller over sACN and just cannot seem to get anything to work.
Both are on the same network. I believe I have all the settings correct but when I patch in my pixels for my LED tape it just doesn't do anything.
We have an ION here onsite, but it is being used in a show currently and I don't have access to just mess around with it till Monday.
I'm going to try to use my ION console on Monday and see if I can get any results using that instead but figured I would post here and see if anyone had any suggestions.
For context I'm using:
LED tape - BTF Lighting WS2815
wLED controller - QuinLED-Dig-Quad
In the end we are trying to use this to do pixel control on led strips for a few sets of staircases using the ION for a show.
I just cannot for the life of me get any control of the LED strips using my NOMAD program
