I recently added some generic small led washes to use as footlights for my theatre. I programmed them into all the cues but during a run through noticed that after a certain point in the show they wouldn’t turn on anymore. I tested this by setting the channels to FL and holding them in the command line hitting go to cycle though the whole show and realized as soon as i hit the first blackout (about halfway through the show) they turned off. I thought that was a me issue but i hit the back button and sure enough they turned right back on. Im not using any subs in this show (nor do we have any of them mapped to anything) so they aren’t being affected by that. And the live table/magic sheet/augmented 3d model still shows them on while being off in the physical space. My quick fix was for whenever channels were zebra i went in cue by cue and changed them all to 0.1% and that seemed to fix it. But im looking for an actual fix/answer for why this is happening?