• Date
    jrgoss
  • Date
  • Replies 7 replies
  • Subscribers 188 subscribers
  • Views 7116 views
  • Users 0 members are here

Playback on iRFR

I was using my iPad (running 4.2.1) to playback some checkout cues that I wrote on a dedicated cue list. (cue list 11) Using the Cue Playback controls, I could goto cue 11/1, but when I hit GO, it would trigger the first cue in cue list 1 (which is loaded onto the main faders), and then continue with all the remaining cues in that list.

If I released cue list 1 from the main faders & loaded cue list 11 onto those faders, all was good, & I could run the cuelist without problem from the iPad.

I experienced the same situation using the Go button on the Virtual RFR part of the software.

So it looks like the iRFR software is limited in that the cue playback will only affect the cues loaded onto the main faders. Can this be fixed/changed in future upgrades? 

(Eos software version 1.9.1, iRFR software version 1.1.42)

Thanks!

Parents

  • You must go into the virtual RFR, go into playback, then [load cue] 11.. enter.  This loads the cue onto the fader of the console the ipad is attached to.  Then you can go from playback and hit go to your hearts content.  A goto command will load and put into the cue on a virtual playback.

     

    Jay

Reply

  • You must go into the virtual RFR, go into playback, then [load cue] 11.. enter.  This loads the cue onto the fader of the console the ipad is attached to.  Then you can go from playback and hit go to your hearts content.  A goto command will load and put into the cue on a virtual playback.

     

    Jay

Children
Related

www.etcconnect.com