irfr preview unable to connect

I made a network between my ion, a D-link router (dir-600) and my iphone. According to my setting of my iphone I have a good connection with my router.

When i start up the application iRFR preview and add my ion as an console it shows it has good connection.

If I go back to the welcome-page of the iRFR preview and try to connect, it connects only for a fraction of a second to my Ion.

Can anybody tell me what I did wrong? I tried it with changing IP-addresses but that didn't make any difference.

Thanks

Edwin

Parents

0 jross over 14 years ago

Edwin,

This seems to be a problem with your wireless router. What I would do first is do a hard reset of your router.

Try that and see if that works...

Jared
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 jross over 14 years ago

Edwin,

This seems to be a problem with your wireless router. What I would do first is do a hard reset of your router.

Try that and see if that works...

Jared
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Edwin van Steenbergen over 14 years ago in reply to jross

why do you think it is the router? I can connact to my router I just cannot let iRFR preview get connected to the computer. My iphone says it is connected to my router (very good connection)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 LowellOlcott over 14 years ago in reply to Edwin van Steenbergen

Edwin, do you enable iPhone/iPod Remotes in the Shell?

If not:

Exit Ion

Click on Settings

Click on RFR

There is a check box for the remotes.

Let me know if this helps!

-Lowell
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 jross over 14 years ago in reply to Edwin van Steenbergen

The reason I thought it was your router was that the ION would not allow you on briefly and then disconnect you. What else I would try is delete the app and redownload it form the app store. Sometimes you can have a bad app download. Also confirm that you have in settings, Allow iRFR.

Hope this helps!

Jared
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Edwin van Steenbergen over 14 years ago in reply to LowellOlcott

yes i already did anable it
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 jross over 14 years ago in reply to Edwin van Steenbergen

Edwin,

Have you confirmed this information? http://community.etcconnect.com/wikis/products/irfr-how-to-setup-your-wireless-network.aspx

Take a look at that wiki and see how it works after that?

Jared
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel