Afternoon Everyone,
I am using some Alpha 1500 Profiles and have found some issues with the fixture in the desk, so have made a new one to try and remedy this. However 2nd Gobo Wheel is a little odd.
The gobo selection is either 1 or 2 slots behind at any point. (The following example has Channel State, Encoder State and Actual State)
F1 - open - Open
F2 - gobo 1 - Open
F3 - gobo 2 - Slot 1
F4 - gobo 3 - Slot 2
F5 - gobo 4 - Slot 3
F6 - gobo 5 - Slot 5
F7 - gobo 6 - Slot 5
F8 - open - Slot 6
I have been into the fixture builder and checked the ranges and it all seems to match up with the data in the manual, and no amount of me tinkering with numbers makes the gobo do anything different. Am I missing a trick somewhere?
