Fader Wing Bump Button and Ipad/ipod issue

Hi ,

I have just updated to v1.9.6 and Have noticed the two following.....

1. When recording to subs, the normal way that i record to the subs has been by pressing RECORD then the Subs lower bump button (this is too a non-existing sub).nothing happens now.....but when I use the same record steps to an existing recorded sub , then this process works...

2. on my ipad and ipod , in the Virtual RFR screen, I have lost 2 x function buttons. One is the OUT and the other I can not remember because I can not see it, i think it had something to do with toggling to more display function....

If you can assist this would be great....

Kind Regards

Jon

0 jross over 14 years ago

I don't want to answer question 1 incorrectly, so I am gonna let someone else grab that one!

I can however answer your second question! When 1.9.5 came out this changed the format of the iRFR. It now starts up in default in channel check opposed to previously in Live mode. To switch to live mode to get the OUT function and the additional functions of live mode, as well as to switch to other modes, there is an M on all screens, hold that down and you will get a new set of menus to switch to the different modes.

Hope this helps!

Jared
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Jon D over 14 years ago in reply to jross

Thank You Jared. this has done the trick for my Part two...have a good day.

Jon
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Steve Bailey over 14 years ago

They changed the function slightly.

When doing the first record of the sub, press Record, then BOTH bump buttons, as if you were loading.

If re-recording the sub, Record, press the lower bump only, then Enter as it's asking to confirm.

SB
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Jon D over 14 years ago in reply to Steve Bailey

Thank You for your time replying Steve..cheers

Jon
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel