Group bringing up entire rig

Hello All,

So, I am trying to record a group or three conventional fixtures on a boom. The group in question is group 13. I double check the group screen and there is not a group 13. Then I enter:

[1] [thru] [5] [Record] [Group] [7] [Enter]

I then go back to the group screen and see group 13 as:

1>90 92 93 95 96 98>300 302>499 501>508 512>2000 4560

Anything above about channel 250 is junk.

Any suggestions!?

Thanks much

Parents

0 Pat Immel over 14 years ago

Update...

we wrote the group in blind in the group screen and all recorded fine! The problems occur when recording groups in live.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Pat Immel over 14 years ago

Update...

we wrote the group in blind in the group screen and all recorded fine! The problems occur when recording groups in live.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 David_Hately over 14 years ago in reply to Pat Immel

There are so many possibilities here:

Are you working on a desk with other programmers?

Are you an incoming programmer working on a house desk with a house patch?

Do you know if the erroneous channel numbers actually do something on the rig? Or a previous rig?

Have you started a 'new show' on the desk from scratch and faced the same problem?

I hope you can provide some clarification so that we can help you further.

David.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel