Fader wing "switched off"

Joanna,

I've replied to your post over at ControlBooth at http://www.controlbooth.com/forums/lighting-electrics/24266-helllllllllp-ion.html.

For the ETC Forums community, here was my response:

Is the logo being displayed, or is there just a line displayed across the middle of the LCD? When you start a new show, the LCD will not have any submasters or faders assigned to it. It is very easy to place in blank submasters to make programming easier -- press [Sub] [Sub] to go into Blind Sub List, and then type [Sub] [1] [Thru] [Thru] [4] [0] [Enter]. This will create 40 blank submasters. You can then assign them by going into [Live] and typing [Sub] [1] [Thru] [4] [0] [Enter] and then tap both the buttons beneath the first fader to have them sequentially assigned to the faders.

(Of course, if you have a 1x20 or 2x10 wing, you may only want to create 20 submasters. Or 100 -- however many you want.)

Joanna,

I've replied to your post over at ControlBooth at http://www.controlbooth.com/forums/lighting-electrics/24266-helllllllllp-ion.html.

For the ETC Forums community, here was my response:

Is the logo being displayed, or is there just a line displayed across the middle of the LCD? When you start a new show, the LCD will not have any submasters or faders assigned to it. It is very easy to place in blank submasters to make programming easier -- press [Sub] [Sub] to go into Blind Sub List, and then type [Sub] [1] [Thru] [Thru] [4] [0] [Enter]. This will create 40 blank submasters. You can then assign them by going into [Live] and typing [Sub] [1] [Thru] [4] [0] [Enter] and then tap both the buttons beneath the first fader to have them sequentially assigned to the faders.

(Of course, if you have a 1x20 or 2x10 wing, you may only want to create 20 submasters. Or 100 -- however many you want.)