eos/ion fixture

Hi Andy,

To add "Fine" control to parameters you need to change the {Size} to 16-bit.

In the fixture editor, select the Pan parameter and hit {Size}, this will change it to 16-bit and amend the LDMX column to the next dmx address and bump the rest of the DMX addresses up by one. Repeat for Tilt. Bob's your uncle.

-M

That's not quite it - remember I said the problem was that the pan & tilt fine contro channnels were not consequetive with the pan & tilt coarse. However it does seem that altering the LDMX values to the channel numbers that the fine are actulally on does the trick.

Subject to the board actually controlling the fixtures which I don't get to confirm till later on today of course.....

Andt

That's not quite it - remember I said the problem was that the pan & tilt fine contro channnels were not consequetive with the pan & tilt coarse. However it does seem that altering the LDMX values to the channel numbers that the fine are actulally on does the trick.

Subject to the board actually controlling the fixtures which I don't get to confirm till later on today of course.....

Andt

Hey Andy,

Sorry, I really shouldn't post before I've had my first cup of coffee... But yes, changing the LDMX value should do the trick.

-M