Every time I turn on my Ion I have to press (Go To Cue) (Out) before I can use the moving lights. There are attributes of the moving lights that are always at a specific value every time I turn on the board. Its kind of annoying.
Every time I turn on my Ion I have to press (Go To Cue) (Out) before I can use the moving lights. There are attributes of the moving lights that are always at a specific value every time I turn on the board. Its kind of annoying.
Do you press Go to Cue Out prior to shutdown ?.
I will try this to see if that fixes the issue. Thanks
You might also check the "Home" values of the fixtures profiles.This should be where your fixtures go when they are "out".
Home can also be set via a preset (I use 1000) as declared in CIA> Setup> Show "home preset"
You might also check the "Home" values of the fixtures profiles.This should be where your fixtures go when they are "out".
Home can also be set via a preset (I use 1000) as declared in CIA> Setup> Show "home preset"
www.etcconnect.com