Ion Playback Status Master Fader Page Display

Hello,
I have maybe tha same problem. I have not proble with listing on fader wing subpages. But I have problem that on LCD main screen in playback status I see only pages 21-30 and pages 30 is highlited, but I have only 4 pages on submasters that I need see only 1-20 pages.
How I can switch this pages on MAIN monitor?
On our second ION is show only masters 1-20, but on this new dest I see only 21-30
Thanks for your time

I tell that I have a fader wink. But stil I see pages 21-30 on masters, how I can change it?

try pressing and holding the button FaderControls, type number 1, and then let go of the button Fader Controls.
better?

Hello,

I try it, press and holt FaderControl put from numeric keybor 1 and relese, not this sequence do nothink.

Changinc pages on Fadewing is no problem.
We have two consoles, left pictures show good state on our main desk, and second picture show bad state on "touring desk"

 

Sory for bad quality.

Hello,

Looks like you're using an earlier version than 2.4. 

While you have focus on your PSD tab, try pessing ] on your external keyboard. 

Note: You'll have to cycle through the faders using ] before the page changes.

Here's the result.

 

Is this what you'd like to have happen?

BTW this does not work with v2.5 and possibly v2.4

Regards,

Johnny

Hello,

Looks like you're using an earlier version than 2.4. 

While you have focus on your PSD tab, try pessing ] on your external keyboard. 

Note: You'll have to cycle through the faders using ] before the page changes.

Here's the result.

 

Is this what you'd like to have happen?

BTW this does not work with v2.5 and possibly v2.4

Regards,

Johnny

Yes, in desk is 2.2. SW version, actualisation is not actually possible.

But, how is correct sequence?
When I higlited PSD table, I have in console "LIVE: CUE 1: - you have only LIVE.
Vhen I press ] this character only write to console but enter not work...

You only see Live in my screen shots because I I do not have any cues recorded.

When you've highlighted your PSD, put your finger on the ] key and then look at your PSD, while pressing the ] key a couple of times. It may take 9 times because it has to cycle through every sub before changing to the next page.

IMPORTANT TO KNOW! Make sure Scroll Lock is off on the external keyboard. This is why you're seeing ]]]]] in your command line.

Yes! The scrol-lock! This cause that I see ]]]].
Thank you very much for your attention!

Mirek
Theaatre Husa na provázku Brno Czech.

Happy to help! :)