Augment3d tab opening on primary when on tether mode

Question

Hey everyone, 
 
 I'm just trying out the Hamilton show file and have been running into a bit of an issue, When I hit GO on my primary, it goes to the next Q, but opens an Augment3d tab on the primary, which displays nothing because I am using a tether. 
 
 I also am running into a bit of an issue where whenever the camera angle changes (not sure how that's been achieved but it's cool!) the graphics settings get reset to 'high' and 60 fps, which is too much for my pc to handle. 
 
 Any tips? 
 
 Thanks, Ben

DavidJArch · Accepted Answer

HI Ben, As turingtest2 suggested, go thru and re-record or update each snapshot so the A3d tab displays where and what you need.That will fix your issue.

Augment3d tab opening on primary when on tether mode

Top Replies