Variable forms and unsharpness for conventional fixtures - Augment3d View

For conventional fixtures or floodlights, for example with barndoors or fresnel, the beam on surfaces should be adjustable in the form and size accordingly.

Simple Exemple:

Also the colour should be adjustable if, for example, color filter foil is used.

Many thanks to the team for the great work on version 3!

prinzip

Top Comments

Matthias Kammueller over 4 years ago in reply to Matthew Dyas +2

you need to specify the gel manufacturer as well, e.g. L200 for Lee 200. Just in the way as written in the live table when you give a gel to a LED device
Matt Pumplin over 3 years ago in reply to Dionysus +1

This can be done in v3.0.0. Use the "Beam Edge" value in Patch > Augmented3. The range is 0 to 100 where 0 is "all the way in" and 100 is "all the way out". 50 gives a sharp edge. If there is no value…

Parents

Dionysus over 4 years ago

I'd also love to run the barrel on the virtual Source-4 or LED Source-4!
- Cancel
- Vote Up 0 Vote Down
- More
- Cancel
Matt Pumplin over 3 years ago in reply to Dionysus

This can be done in v3.0.0. Use the "Beam Edge" value in Patch > Augmented3. The range is 0 to 100 where 0 is "all the way in" and 100 is "all the way out". 50 gives a sharp edge. If there is no value, it will behavie like 50.

In this screenshot, from left to right are [no value], 0, 50, and 100
- Cancel
- Vote Up +1 Vote Down
- More
- Cancel

Comment

Matt Pumplin over 3 years ago in reply to Dionysus

This can be done in v3.0.0. Use the "Beam Edge" value in Patch > Augmented3. The range is 0 to 100 where 0 is "all the way in" and 100 is "all the way out". 50 gives a sharp edge. If there is no value, it will behavie like 50.

In this screenshot, from left to right are [no value], 0, 50, and 100
- Cancel
- Vote Up +1 Vote Down
- More
- Cancel

Children

No Data