We have 2 hazers (Jem K1) which we control haze output from the Hog4 lighting console. At the end of the show when we shutdown the lighting console both hazers run at 100% as soon as they loose dmx signal. We have been manually going backstage and proceed to unplug both of the hazers to power them off. I noticed that when we patched the Jem K1 hazers it has a control option to shutdown the fixtures. We have tried this and can't seem to get it to work. As soon as we shut down the board, they both run at 100%. Is there a way to eliminate the need to have to unplug the hazers
Mlorenz- it sounds like your on to something, and thanks for your help. How do I change shutdown value for 3 mins. Would this be on the K1 Jem hazers or on Hog4pc? I do know that once they are unplugged, they do cycle through a 3 minute shutdown, so I think that may be where I'm messing up. Do I just select the hazers fixture numbers and hit control and press fixture shutdown and wait 3 minutes before shutting the board down, or is there another proper way. Thanks for your help.
Mlorenz- it sounds like your on to something, and thanks for your help. How do I change shutdown value for 3 mins. Would this be on the K1 Jem hazers or on Hog4pc? I do know that once they are unplugged, they do cycle through a 3 minute shutdown, so I think that may be where I'm messing up. Do I just select the hazers fixture numbers and hit control and press fixture shutdown and wait 3 minutes before shutting the board down, or is there another proper way. Thanks for your help.
