Upgrading a Legacy Insight

Just came upon a venue with a legacy Insight...I had never seen this older software on an ETC "Express Family" console before. This is the much older, DOS-looking, multi-colored (I assume original) software.

Can I install newer Expression software on it? Or is the hardware too old?

Parents

Hans.Hinrichsen over 13 years ago

Is this an Insight (1) or an Insight 2 (or 2x)?

http://community.etcconnect.com/wikis/products/expression-insight-consoles.aspx

This will make a difference as to what software can be installed on it.

Hans
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
ldsfx over 13 years ago in reply to Hans.Hinrichsen

It is an Insight 1 ....so I am assuming the answer is no?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

ldsfx over 13 years ago in reply to Hans.Hinrichsen

It is an Insight 1 ....so I am assuming the answer is no?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

Joe_ML over 13 years ago in reply to ldsfx

What about a Insight 3?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Richard over 13 years ago in reply to Joe_ML

An Insight 3 is probably already running the latest - the newest is v3.1.1, which you can download from here.

- Note that this download is the 'standalone' Expression software, not Express(ion) with Emphasis.

I should probably point out that all Expression software is "DOS-looking".

[edited by: Richard at 4:27 AM (GMT -6) on Thu, May 5 2011]
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Joe_ML over 13 years ago in reply to Richard

Richard said:

An Insight 3 is probably already running the latest - the newest is v3.1.1

You are correct, didn't know if it would be backwards compatible. As in New software on old console.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel