Sometimes our ColorPro HX lights lose track of where a wheel is and I would like to home the fixture in order to get things reset. I do this on our Hog 500 by going into the BEAM settings and selecting HOME and then closing the shutter. Unfortunately this often has the side effect of turning off the lamp. Is there a way to avoid this? Am I using the wrong procedure to home the light?
My typical procedure was to leave the strobe open, set the control to what I wanted and then close the strobe. This also avoid sending unintended controls.
It seems that simply closing the strobe can cause them to lamp off, so anything I try to do in conjunction with that has the side effect of turning off the lamp.
My typical procedure was to leave the strobe open, set the control to what I wanted and then close the strobe. This also avoid sending unintended controls.
It seems that simply closing the strobe can cause them to lamp off, so anything I try to do in conjunction with that has the side effect of turning off the lamp.
