Hog II and colorblast 12's

As Colorblasts only have RGB...yes, the Generic RGB will work.

well...that was painless, thanks for the info much appreciated

Hey, can you use colorblaze 72s under the same profile? I use the c series on hog 500. Thanks:hogsign:

Yes, just patch the appropriate number of cells that you set the Colorblaze to.

When patched as generic RGB in Hog 2, can one control overall intensity via a fader, effectively creating a virtual intensity channel? I didn't think so, but if not how does one deal with leds on a Hog 2? Do you need to run an "all channels at zero" cue every time you want to turn the fixture's output off? How would one go about busking a show with leds on a Hog 2/1000?

[quote=loebus]When patched as generic RGB in Hog 2, can one control overall intensity via a fader, effectively creating a virtual intensity channel? I didn't think so, but if not how does one deal with leds on a Hog 2? Do you need to run an "all channels at zero" cue every time you want to turn the fixture's output off? How would one go about busking a show with leds on a Hog 2/1000?

Hey Brooke,

It looks like they are really talking about Hog-3 above as there is no "Generic RGB" on H2.

the best way I found to use LEDs on the old H2 system is to use a profile that makes the console "think" of the parameters as 3 separate intensities....so when you pull down a handle or the GM they fade accordingly.

See attached profile I wrote years ago....it will show up in the "Generic" manufacturer libraries with Desk Channels and such.

Hope this helps you out! See you in SF again one of these days:)