hog 2 and wysiwyg 10

I have a question:
is possible using hog2pc with wysiwyg10 full version?

thanks

francomaria
Parents
  • OK, here's what you do . . . First, make sure that you have the Wyg extension to H2PC loaded. Then, in Wyg, go to the "Data" section, and then select "Patch". Define however many universes that you want to use with H2PC. Once that is done, go to the "Live" section in Wyg, and then pull down "Device Manager" from "Live". If you have not yet defined the Hog2, then hit "New" and do so. Once that is done, go into it (properties) and select each H2 output - 1 through 4, double click it, and define which Wyg universe you want that output to drive. Patch your fixtures in Wyg accordingly. Oh, and if you don't see "Connected" in the Device Manager screen, go back and look to be sure that you put in the Wyg driver to H2.

    - Tim
Reply
  • OK, here's what you do . . . First, make sure that you have the Wyg extension to H2PC loaded. Then, in Wyg, go to the "Data" section, and then select "Patch". Define however many universes that you want to use with H2PC. Once that is done, go to the "Live" section in Wyg, and then pull down "Device Manager" from "Live". If you have not yet defined the Hog2, then hit "New" and do so. Once that is done, go into it (properties) and select each H2 output - 1 through 4, double click it, and define which Wyg universe you want that output to drive. Patch your fixtures in Wyg accordingly. Oh, and if you don't see "Connected" in the Device Manager screen, go back and look to be sure that you put in the Wyg driver to H2.

    - Tim
Children
No Data
Related