Cailbration XYZ on HOG 1000

Yesterday i tried for the first time to program position with XYZ axis on HOG 1000, but by operating manual it doesn't work. In manual is a few information, but in real programing i don't know, what to do. After pressing calibrate is displaied inscription that can't find palettes cal DSR...but this palettes I created before a named DSR, DSL , etc. Naming position like DSR, DSL..etc doesn't help, pressing twice ,set' doesn't help too. I don't understand this. I miss some real mode for this mode, where can i enter data of width, height and depth of stage. After one hour experiments i write here, to consult this with somebody. Does work this way of programing on HOG 1000? Has somebody better and bigger aproach how to get position in XYZ mode?
Thanks for an answer.
George
Parents
  • 0
    If memory serves you need to not only creat the palette, but you need to assign it as a "calibration" palette.

    I can't remember if this is done with a right click on mous out using Set Key.....look in the Hog 2 manula for specifics.

    Also, not all fixture profiles will work with XYZ coordinates.....you need to check you profiles as well to be sure they have the appropriate info in them.

    Plently of good info in the Hog 2 manual here:

    www.flyingpig.com/support/hog2/manuals/hog2_v4.pdf

    Hope this helps. :)
Reply
  • 0
    If memory serves you need to not only creat the palette, but you need to assign it as a "calibration" palette.

    I can't remember if this is done with a right click on mous out using Set Key.....look in the Hog 2 manula for specifics.

    Also, not all fixture profiles will work with XYZ coordinates.....you need to check you profiles as well to be sure they have the appropriate info in them.

    Plently of good info in the Hog 2 manual here:

    www.flyingpig.com/support/hog2/manuals/hog2_v4.pdf

    Hope this helps. :)
Children
No Data
Related

www.etcconnect.com